sony KV32TS20 Repair Tips




Search: KV32TS20 sony
Results 11
MakeModel Ch.SymptomProblem SolutionSolutionBy:
Sony KV32TS20
Dead, good tip that I always use to save changed parts after replacing Q502, Q601, Q602 and blown fuse 602I hook up 100 watt light bulb across fuse conection, then turn on tv, if light is very bright you still have a short. You saved the parts you changed, light should be dim and or blinks
Sony KV32TS20
Dead no click, Q502, Q601, Q602 shorted and blown fuse 602Change all the above parts and also check R647, C512, C525, D607, D608, D609, D610, D622, VDR601 off primary side of T605. I`ve also found T605 bad too. ToughDog, Sony has bulletin out on this model
SonyKV32TS20
NO REMOTE FUNCTION, REPLACED IC102 Replace IC102.
SonyKV32TS20
POWER ONLY, REPLACED IC101 No sound, video, or remote control. Manual power switchOK. Horizontal circuit working and has high voltage.
SonyKV32TS20
PART NUMBERS FOR # 5 AND 15 MISSING, SEE P/N BELOW Need the part number for both reference number 5 and 15. Ref. Description Part Number 5 T. Rivet 4-397-418-01 15 Ant. Term. plate 4-031-420-01
SonyKV32TS20
DISTORTION IN PICTURE, REPLACED YOKE Distortion on top and bottom of picture. Similar to flagwaving. Yoke was running hot. Found defective yoke. The yoke did checkOK on the Z meter.
SonyKV32TS20
CRT MOUNTS NOT LISTED IN SERVICE MANUAL, REFER S/M KV-27TS29 The white CRT mounting pieces with bolt are not in the servicemanual and do not come with the front cabinet. Help! -HQ COMMENTS: Please refer to the Service Manual for KV-27TS29, page102.Reference 56 Support (Right) 4-031-428-01 57 Su
SonyKV32TS20
TV DEAD, REPLACED T605, R647, AND D622 TV dead. No standby 5V.
SonyKV32TS20
SNOWY PICTURE, REPLACED TUNER Picture becomes snowy after 10 minutes of playing. This alsoappears with KV27TS27, KV10TS20, and KV32TW75.
SonyKV32TS20
ON SCREEN DISPLAY REMAINS ON, D601 SHORTED The display button must be pressed twice to turn off OSD, butwhen using an adjustment function as volume or picture, the display staysall the time.
SonyKV32TS20
NO PICTURE/SOUND, REPLACED R-648 The set will not turn on. This is due to R-648 opening up.R-648 is located off of T-605/pin 4, in the standby supply. When itopens the standby, 5V is not present. Replacement resolves the problem.Note: We have received several reports of this failure.